Allen-Bradley SMC-50 User Manual

Rockwell Automation Publication 1560F-UM001A-EN-P - June 2019 155
Diagnostics Chapter 8
Auxiliary Relay Output
Fault or Alarm Indication
You can program Auxiliary Relay Output contacts for Fault or Alarm, N.O., or
N.C. indication. You can also configure an ON or OFF Delay Time. Basic
parameter setup (without N.C. or timed functions) is in the Setup / I/O
Parameter Group. Full configuration is available from the Setup / I/O Parameter
Group.
Start 71 N
A
N
A
N
A
This is an Event Code and is
stored in the Alarm Buffer
for:
Start Event tracking.
Stop Option 73 N
A
N
A
N
A
Stop Option Event tracking.
Coast 74 N
A
N
A
N
A
Coast Event tracking.
Clear Fault 75 N
A
N
A
N
A
Clear Fault Event tracking.
Fault 76 N
A
N
A
N
A
Fault Event tracking.
Parm Change 77 N
A
N
A
N
A
Parameter Change Event tracking.
Reserved 78…9
9
NNNFuture Use.
System Faults 100…
199
NNN
A
A general Fault/Alarm typically associated with the SMC-50 control
module hardware (for example, system Watchdog Time failure).
(1) Overload is inherently a time-based fault.
Table 57 - Linear Listing—Fault and Alarm Code Overview (Continued)
Fault/Alarm
Code Name
F/A Code
Time Delay Avail.
F/A Bit Enable
Restart Enable
Description
F/A= Fault and Alarm, A= Alarm, F= Fault

Allen-Bradley SMC-50 Specifications

General

Brand	Allen-Bradley
Model	SMC-50
Category	Controller
Language	English