Allen-Bradley SMC-50 - Parameter Configuration - Using the Setup File Group; Overview

96 Rockwell Automation Publication 1560F-UM001A-EN-P - June 2019
Chapter 4 Programming
Parameter Configuration -
Using the Setup File Group
Overview
Table 11 shows the parameter sets available within the Basic Setup group.
Table 11 - Setup File Group
The Basic parameter set in the setup group is limited, yet powerful. It lets you
quickly start the system with minimal adjustments and provides quick access to
parameters that are required for standard motor connection and overload
protection. If you are using advanced controller features (for example, Dual
Ramp), however, you must also use the parameter set that is associated with those
features. The Setup group is used throughout this section as a baseline for system
configuration.
Setup File Group Parameters
Basic (BA) Starting (BA) Stopping (BA)
Dual Ramp
(BA)
Advanced I/O (BA) Advanced Tuning
Motor Config Input 2 Starting Mode Stop Mode Starting Mode 2 Pump Pedestal (A) Input 1 Force Tuning (A) Phase Shift 0% (A)
Line Voltage Aux 1 Config Ramp Time Stop Time Ramp Time 2 Load Type (A) Input 2 Starter R Phase Shift 10% (A)
Starting
Mode
Aux 2 Config Cur Limit Level Backspin Timer Cur Limit Level 2 UTS Level (A) Aux 1 Config Total R Phase Shift 20% (A)
Overload
Class
Initial Torque Initial Torque 2 Stall Position (A) Aux 1 Invert Coupling Factor Phase Shift 30% (A)
Ramp Time Starting Torque Starting Torque 2 Stall Level (A) Aux 1 On Delay Inductance Phase Shift 40% (A)
Initial Torque Service
Factor
Max Torque Max Torque 2 V Shut Off Level (A) Aux 1 Off Delay Speed PGain (A) Phase Shift 50% (A)
Max Torque Kickstart Time Kickstart Time 2 I Shut Off Level (A) Aux 2 Config Transient Gain
(A)
Phase Shift 60% (A)
Cur Limit
Level
Motor FLC Kickstart Level Kickstart Level 2 Notch Maximum (A) Aux 2 Invert Phase Shift 70% (A)
Starting
Tor qu e
Start Delay Timed Start (A) Aux 2 On Delay Transient Zero
(A)
Phase Shift 80% (A)
Stop Mode Bypass Delay (A) Aux 2 Off Delay Phase Shift 90% (A)
Stop Time Max Torque Demand Period (BA) Aux Control Transient Mag
(A)
Phase Shift 100% (A)
Input 1 Rated Torque Num of Periods (BA)
Rated Speed Ping Degree (A)
Pings (A)
TIP For a complete parameter set listing within each parameter File—Group,
see Parameter File-Group Structure
on page 109.
IMPORTANT Parameter values that are modified while the motor is operating are not valid
until the next time the operation for that parameter occurs.
ATTENTION: For Overload Protection, it is critical that you enter the data into
the SMC-50 control module as it appears on the motor nameplate.