6-21 Access Profile Table
Configur
ing the Access Profile Table
Access profiles allow you to establish criteria to determine whether or not the Switch will forward packets based on the information contained in each packet's
header.These criteria can be specified on a basis of VLAN, MAC address or IP address.
Creating an access profile is divided into two basic parts.The first is to specify which part or parts of a frame the Switch will examine, such as the MAC source
address or the IP destination address.The second part is entering the criteria the Switch will use to determine what to do with the frame.The entire process is
described below in two parts.
To display the currently configured Access Profiles on the Switch, open the
Configuration folder and click on the Access Profile Table link.This will open
the
Access Profile Table page, as shown below.
Figure 6- 60.Access Profile Table
To add an entry to the
Access Profile Table, click the Add button.This will open the Access Profile Configuration page, as shown below.There are
three
Access Profile Configuration pages; one for Ethernet (or MAC address-based) profile configuration, one for IP address-based profile configuration
and one for the
Packet Content Mask.You can switch between the three Access Profile Configuration pages by using the Type drop-down menu.
The page shown below is the
Ethernet Access Profile Configuration page.
Figure 6- 61.Access Profile Table (Ethernet)
76
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
To Next Page
Loading...
Need help?
General
Weight and Dimensions
