Allied Telesis AT-9724TS User Manual

To setup RIP for the IP interfaces configured on the Switch, the user must enable RIP and then configure RIP settings for the individual IP interfaces.To globally
enable RIP on the Switch, open the Configuration folder to Layer 3 Networking and then open the RIP folder and click on the RIP Configuration
link to access the following screen:
Figure 6- 95. RIP Global Setting window
To enable RIP, simply use the pull down menu, select
Enabled and click Apply.
Setting Up RIP
RIP settings are configured for each IP interface on the Switch. Click the RIP Interface Settings link in the RIP folder.The menu appears in table form listing
settings for IP interfaces currently on the Switch.To configure RIP settings for an individual interface, click on the hyperlinked
Interface Name.To view the
next page of RIP Interface Settings, click the
Next button.
Figure 6- 96. RIP Interface Settings window
Click the hyperlinked name of the interface you want to set up for RIP, which will give access to the following menu:
Figure 6- 97. RIP Interface Settings – Edit window
Refer to the table below for a description of the a
vailable parameters for RIP interface settings.
The following RIP settings can be a
pplied to each IP interface:
102
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g