Alpha-InnoTec Luxtronik 2.0 - Page 80

80
We reserve the right to make technical changes.
83052300eUK © ait-deutschland GmbH
Parameter Factory setting Setting Start-up Value range Access
heat quantity
only Luxtronik 2.1
Fitter
time pump ow
only Luxtronik 2.0
1 min min 1 - 5 min
Fitter
min defrost
cycle
45 min min 45 • 60 • 90 • 120 • 180 • 240 • 300
Fitter
time 2.CP short
only Luxtronik 2.0
min min 5 20 min
Fitter
TDI Message
Yes No • Yes *) No • Yes
Fitter
release 2hg
60 min min 20 min - 120 min
Fitter
aux. heat. hot
water
No No • Yes *) No • Yes
Fitter
aux.serv.water
max
– min 20 min - 120 min
Fitter
Second heat gen.
1 Type
only Luxtronik 2.1
No No • El. Rod • Boiler • Thermal *) No • El. Rod • Boiler • Thermal
Fitter
Second heat gen.
1 Function
only Luxtronik 2.1
No No • Heating • Heating a SW *) No • Heating • Heating a SW
Fitter
Second heat gen.
1 Position
only Luxtronik 2.1
– – – – – – • Tank • integrated *) – – – • Tank • integrated
Fitter
Second heat gen.
2 Type
only Luxtronik 2.1
No No • El. Rod *) No • El. Rod.
Fitter
Second heat gen.
2 Function
only Luxtronik 2.1
No No • Heating • SW *) No • Heating • SW
Fitter
Second heat gen.
2 Position
only Luxtronik 2.1
– – – – – – • Tank • integrated *) – – – • Tank • integrated
Fitter
*) Please enter value or cross out if not applicable