Alpitronic hypercharger HYC50 - 2.1. Charging Interfaces

HYC50 - Operation and Installation Guide
Version 2-2
Page 20 of 102
2 Product description
All rights reserved. Reproduction of this document, even in part, is only permitted with the approval of alpitronic Srl.
2.1. Charging interfaces
The following charging interfaces can be selected for the HYC50 in various combinations.
Active cooling is not provided for any of the cable variants.
Charging interfaces
Charging interface
Voltage [V]
Current [A]
Min.
Max.
Min.
Max.
CCS Combo 2
150 V DC
1,000 V DC
6.5 A
150 A DC
CHAdeMO
150 V DC
500 V DC
6.5 A
125 A DC
CCS Combo 1
150 V DC
1,000 V DC
6.5 A
150 A DC
Table 1: Charging interfaces
Notice
The total power of the HYC50 is limited to a maximum current rating of
90 Arms on the AC input side.
The usable DC power of the HYC50 is limited by the maximum current of
the DC charging cable used.
The charging cables CCS1 and CCS2 can be equipped with temperature
sensors that can derate the maximum available charging current when
the defined temperature limits are reached.
Please note that CHAdeMO cables can only be operated at a maximum
altitude of 2,000 m above the sea level.
The following charging cable combinations are possible:
Charging interfaces
Charging cable 1 (left)
Charging cable 2 (right)
CCS1/2
N/A
CCS1/2
CCS1/2
N/A
CCS1/2
CHAdeMO
CCS1/2
CHAdeMO
N/A
Table 2: Possible combinations of charging interfaces