All rights reserved. Reproduction of this document, even in part, is only permitted with the approval of alpitronic Srl.
4.4.4. Mounting the HYC50 and connecting to the mains
Position the packaged HYC50 squarely in front of the pedestal or wall mount plate. Make
sure the side with the marked cutting lines faces the pedestal or wall mount plate.
Figure 34: Position packaged HYC50
Place the charging cables and cable management (if applicable) on the respective sides of
the HYC50 and free the surface of the HYC50 from its protective cover.
Figure 35: Unpack the HYC50
To Next Page