HYC50 - Operation and Installation Guide
Version 2-2
All rights reserved. Reproduction of this document, even in part, is only permitted with the approval of alpitronic Srl.
After opening the service hatch, the lock on the front door can be released and it can be
opened.
Figure 11: Front door locking mechanism
Notice
Two door contact switches are installed as standard in the HYC50, which
detect the opening of the front door and the service hatch.
Condensation on surfaces can lead to defects in charging station
components!
If it is raining, do not open the doors or cover the HYC50 before opening.
If the door is opened as far as it will go, make sure that no greater forces
act on the door beyond the mechanical stop, in order to avoid damaging
(bending) the door hinges. In such a case, for safety reasons, it is
necessary to check whether the tightness of the door is still guaranteed.
Before closing the service hatch, ensure that all protective covers are in
place and the front door is properly locked.
To Next Page