Alpitronic hypercharger HYC50 - Table of Figures

HYC50 - Operation and Installation Guide
Version 2-2
Contents
All rights reserved. Reproduction of this document, even in part, is only permitted with the approval of alpitronic Srl.
Table of Figures
Figure 1: HYC50 with one DC charging cable (position 1 and 2) .......................................18
Figure 2: HYC50 with two DC charging cables ..................................................................18
Figure 3: Order of the charging points HYC50 ..................................................................19
Figure 4: DC power characteristics in different configurations ...........................................21
Figure 5: Cable length for the two DC outputs of the HYC50 with a 4.45 m cable .............22
Figure 6: Elements of the HYC50......................................................................................23
Figure 7: External dimensions of HYC50 with pedestal incl. cable management (in mm) .... 24
Figure 8: External dimensions of HYC50 for wall mounting incl. cable management (in mm) ... 24
Figure 9: Example of a nameplate for hypercharger HYC50 (without calibration law) .......25
Figure 10: Service hatch for access to the HYC50 ............................................................26
Figure 11: Front door locking mechanism .........................................................................27
Figure 12: Interior view of HYC50 (frontal view) ................................................................28
Figure 13: Interior view of HYC50 (lateral view) ................................................................29
Figure 14: HYC50 packaging ............................................................................................32
Figure 15: Recommended and mandatory minimum distances when choosing a location 36
Figure 16: hypercharger concrete foundation (dimensions in cm) .....................................37
Figure 17: Eyebolts for lifting and positioning the foundation.............................................38
Figure 18: HYC50 on a concrete foundation .....................................................................39
Figure 19: Positioning pedestal on foundation ..................................................................40
Figure 20: Mounting the HYC50 pedestal .........................................................................41
Figure 21: Remove the pedestal cover .............................................................................41
Figure 22: Installation height (barrier-free) ........................................................................42
Figure 23: Wall template ...................................................................................................43
Figure 24: Circuit diagram for the HYC50 .........................................................................45
Figure 25: Attach the AC grid connection box ...................................................................49
Figure 26: Removal of cable fixation and protective cover ................................................50
Figure 27: Install mains cable seal ....................................................................................50
Figure 28: Correct length phases and PE conductors .......................................................51
Figure 29: Secure mains cable with strain relief ................................................................52
Figure 30: Attachment of cable terminals ..........................................................................53
Figure 31: Mounting of protective cover via PE cable terminal ..........................................54
Figure 32: Fix phases with cable fixation...........................................................................55
Figure 33: Lead the flexible cable through the opening and fix the cover ..........................56
Figure 34: Position packaged HYC50 ...............................................................................57
Figure 35: Unpack the HYC50 ..........................................................................................57
Figure 36: Mounting aid HYC50 ........................................................................................58
Figure 37: Use mounting aid .............................................................................................58
Figure 38: Position spacer ................................................................................................59
Figure 39: Pre-assembled adapter plate on the HYC50 ....................................................59
Figure 40: Suspension and cable entry HYC50.................................................................60
Figure 41: Pull off mounting aid ........................................................................................61
Figure 42: Remove stickers ..............................................................................................61
Figure 43: Insert connection cables ..................................................................................62
Figure 44: Remove adapter plate ......................................................................................62
Figure 45: Insert plastic cover ...........................................................................................62
Figure 46: First (right) and second (left) attachment point .................................................63
Figure 47: Fasten three phases in the main switch ...........................................................64
Figure 48: Attach protective conductor ..............................................................................65
Figure 49: Third attachment point .....................................................................................66
Figure 50: Attach touch protection ....................................................................................67
Figure 51: Authentication screen ......................................................................................72