Sequoia Series 105
Command Syntax [SOURce:]PONSetup:CURRent <NRf+>
Parameters range set by the LIMit:CURRent, voltage mode and voltage range
Examples PONS:CURR 22
Query Syntax PONS:CURR?
Returned Parameters <NR2>
PONSetup:FREQuency
This command sets the initial frequency of the power source at the power on.
Command Syntax [SOURce:]PONSetup:FREQuncy <NRf+>
Parameters set by the LIMit:FREQuency
Examples PONS:FREQ 50
Query Syntax PONS:FREQ?
Returned Parameters <NR2>
PONSetup:NOUTput
This command sets the configuration of the power source to one phase or three phase if this option is
enabled. The LAST setting causes the unit to power up in the mode it was left.
Command Syntax [SOURce:]PONSetup:NOUTput <selection>
Parameters ONEPhase|THReephase|LAST
Examples PONS:NOUT LAST
Query Syntax PONS:NOUT?
Returned Parameters <CRD>
PONSetup:OLOad[:MODE]
This command determines how the power source will react to an over current condition. In const
current mode, the output voltage is reduced to a value that maintains a constant load current. In
constant voltage mode, the output faults to an initial value if the over current condition is maintained
beyond the protection delay period.
Command Syntax [SOURce:]PONSetup:OLOad[:MODE] <mode>
Parameters CCURrent|CVOLyage
Examples OLOad CCUR
Query Syntax PONS:OLO?
Returned Parameters <CRD>
Related Commands CURR:PROT:STAT
PONSetup:CURRent:PROTection:DELAY
This command is used to set the protetction delay period.
Command Syntax [SOURce:] PONSetup:CURRent: PROTection:DELAY
Parameters 0.1 to 5
Unit Seconds
Examples PONSetup:CURRent:PROTection:DELAY 0.6
Query Syntax PONSetup:CURRent:PROTection:DELAY?
Returned Parameters <NR2>
Related Commands OUTP:PROT:STATE
PONSetup:CURRent:PHASE
To Next Page
Loading...
