108 Sequoia Series
Command Syntax PONSetup:SYNChronize:VOLTage <NRf+>
Parameters <NRf+>
Unit V
Examples PONS:SYNC:VOLT 250
Query Syntax PONSetup:SYNChronize:VOLTage?
Returned Parameters <NR2>
Related Commands SYNC:VOLT?MIN, SYNC:VOLT?MAX
PONSetup:POWer[:REAL]
Sets the Active power required as a load for the UUT at power-on
Command Syntax PONSetup:POWer[:REAL]
Parameters < NRf >
Example PONSetup:POW 20
Query Syntax PONSetup:POWer[:REAL]?
Returned Parameters < NRf >
Related Commands POW:REAL?MIN, POW:REAL?MAX
PONSetup:POWer:REACtive
Sets the Reactive power required as a load for the UUT at power-on
Command Syntax PONSetup:POWer:REACtive
Parameters < NRf >
Example PONSetup:POW:REAC 10
Query Syntax PONSetup:POWer:REACtive ?
Returned Parameters < NRf >
Related Commands POW:REAC?MIN, POW:REAC?MAX
PONSetup:REFerence[:MODE]
This command determines the source of its voltage reference at the power on. if internal, the source
uses its internal voltage. if external, the input must be an external signal. If RPV, the input is a DC
value correspond to the level of the internal oscillator signal.
Command Syntax [SOURce:]PONSetup:REFerence[:MODE] <source>
Parameters INTernal|EXTernal|RPVoltage
Examples PONSetup:REFererence EXT
Query Syntax PONSetup:REF?
Returned Parameters <CRD>
Related Commands PONS:REF:FSC
PONSetup:REFerence:FSCale
This command determines the external voltage reference level at the power on that correspond to the
full scale output voltage.