132 Sequoia Series
SYSTem:COMMunicate:LAN:APPLy
This command will apply the changes in LAN setting. The controller will go to reset condition and the
new LAN setting will take effect.
Command Syntax SYSTem:COMMunicate:LAN:APPLy
Parameters none
Example SYST:COMM:LAN:APPL
Query Syntax no query for this command
Returned Parameters none
SYSTem:COMMunicate:LAN:CLASs
This command will set the number of host address bits or a class. The query format returns the number
of bits set. To query the actual number of bits used by the LAN interface (in case the IP address is not
static but assigned by a DHCP server), the NCON parameter (Network Connection Setting) must be
added to the query. The default value is 8. In general Class A network is 24 bits, Class B is 16 bits and
Class A is 8 bits.
Command Syntax SYSTem:COMMunicate:LAN:CLASs <NRF>
Parameters 8 to 32
Example SYST:COMM:LAN:CLAS 8
Query Syntax SYST:COMM:LAN: CLAS?
SYST:COMM:LAN: CLAS? NCON
Returned Parameters <NR1>
SYSTem:COMMunicate:LAN:DEFault
This command will apply the changes in LAN setting to the default setting. The controller will go to
reset condition and the default LAN setting will take effect. Both IP address and Gate way address are
set to zero. The Host name is cleared. The password is reset to “admin”. The unit is set to DHCP or
Auto IP.
Command Syntax SYSTem:COMMunicate:LAN:DEFault
Parameters none
Example SYST:COMM:LAN:DEF
Query Syntax no query for this command
Returned Parameters none
SYSTem:COMMunicate:LAN:DESCription
This command will set the user description. The description is limited to 24 characters
Command Syntax SYSTem:COMMunicate:LAN:DESCription <SRD>
Parameters <SRD>
Example SYST:COMM:LAN:DESC “EVAL UNIT”
Query Syntax SYST:COMM:LAN:DESC?
Returned Parameters <SRD>