134 Sequoia Series
SYSTem:COMMunicate:LAN:DHCP
This command will enable or disable DHCP
Command Syntax SYSTem:COMMunicate:LAN:DHCP <boolean>
Parameters 0|1 or off|on
Example SYST:COMM:LAN:DHCP on
Query Syntax SYST:COMM:LAN: DHCP?
Returned Parameters <boolean>
SYSTem:COMMunicate:LAN:MDNS
This command will enable or disable MDNS
Command Syntax SYSTem:COMMunicate:LAN:MDNS <boolean>
Parameters 0|1 or off|on
Example SYST:COMM:LAN:MDNS on
Query Syntax SYST:COMM:LAN: MDNS?
Returned Parameters <boollean>
SYSTem:COMMunicate:SERial:BAUD
This command will set the SERial communication baud rate.
Command Syntax SYSTem:COMMunicate:SERial:BAUD <NRF>
Parameters 1200 | 2400 | 4800 | 9600 | 38400 | 57600 | 115200
Example SYST:COMM:SER:BAUD 9600
Returned Parameters <NR1>
SYSTem:COMMunicate:SERial:PARity
This command will set the SERial communication parity.
Command Syntax
SYSTem:COMMun
icate:SERial:PARity <p
arity>
Parameters NONE | EVEN | ODD
Example SYST:COMM:SER:PAR NONE
Returned Parameters <CRD>
To Next Page
Loading...
Need help?
General
