Ametek SEQUOIA Series - Page 141

Sequoia Series 141
TRIGger:ACQuire:SOURce
These commands select the trigger source for a triggered measurement sequence as follows:
IMMediate Acquire the measurements immediate. The FETCh commands return the
requested calculation from the set of acquired data as soon as the
measurement calculations are completed by the controller.
SYNChronize Internal phase A angle
BUS IEEE-488 device, *TRG, or <GET> (Group Execute Trigger)
TTLTrg The signal driving the Trigger Out BNC
Command Syntax TRIGger:ACQuire:SOURce<CRD>
Parameters IMM|SYNC|BUS |TTLT
*RST Value IMM
Examples TRIG:ACQ:SOUR BUS
Query Syntax TRIGger:ACQuire:SOURce?
Returned Parameters <CRD>
Related Commands ABOR TRIG:SOUR TRIG:SYNC:SOUR
TRIG:SYNC:PHAS INIT INIT:CONT *TRG
TRIGger:SYNChronize:SOURce
This command selects the synchronizing trigger source in generating a step, pulse, or list output as
follows:
• IMMediate starts the transient output immediately.
• PHASe starts the transient output at the reference phase set by TRIG:PHAS.
Command Syntax TRIGger:SYNChronize:SOURce <CRD>
Parameters IMMediate|PHASe
*RST Value IMM
Examples TRIG:SYNC:SOUR IMM TRIG:SOUR PHAS
Query Syntax TRIGger:SYNC:SOURce?
Returned Parameters <CRD>
Related Commands ABOR
TRIG:SYNC:PHAS INIT INIT:CONT *TRG
TRIGger:SYNChronize:PHASe
This command sets the phase angle with respect to an internal phase reference if TRIGger:SOURce
PHASe is selected. The range is from -360 to +360 Degrees.
Command Syntax TRIGger:SYNChronize:PHASe<NRf+>
Parameters 360 to +360
*RST Value 0
Examples TRIG:SYNC:PHAS 90
Query Syntax TRIGger:SYNChronize:PHASe?
Returned Parameters <NR2>
Related Commands ABOR TRIG:SYNC:SOUR INIT
INIT:CONT *TRG