Event log displayEvent log display
functionsfunctions
When releasing the finger or stylus, the graph area zooms in to show the
selected part of the graph.
To zoom out, use the view settings below the graph:
View modeView mode
Used to set the x-scaling for the graph. The possible settings are:
Last 24HLast 24H to Last 5mLast 5m: Shows a sliding graph area with max. width of 24 hours to
5 minutes.
View allView all: Shows a graph area with a width as the duration of the test.
CustomCustom: This is automatically selected when the graph area is touch-
manipulated.
Max pointer valueMax pointer value
Used to set the y-scaling of the view. The maximum amplitude of the plot
always originates from the zero line.
55..99..33..33 Event LogEvent Log
Touching the Event LogEvent Log button in the navigation area displays the screen
shown below.
The slide-out panel on the left-hand side of the screen contains the following
event log functions:
Define time format.
Enabling event log filter.
Event log filter configuration.
Clear event log filter configuration.
To Next Page
Loading...
