Selecting the intervalSelecting the interval
timetime
Selecting type ofSelecting type of
resultsresults
Studying a specificStudying a specific
resultresult
This screen presents a detailed analysis of the test results. You can choose to
view either the total results from measurement start or the results of a specific
interval during the test. You can also zoom in on a specific result item. The
results can be displayed either in table (list) form or as a graph.
Selecting which results to viewSelecting which results to view
Touch the TotalTotal button to switch the total values measured in all interval times.
The start time of measurement is displayed on the button.
Touching the button in left side BackBack field shows the measured values in the
interval time. The end time of the interval is displayed on the button.
CurrentCurrent button is displayed at left bottom when the measurement is running.
Touching the CurrentCurrent button shows the measured values in the current interval
time.
The slide-out panel on the left-hand side of the screen contains the following
functions:
Only show intervals that contains errors
Time format
If you have stopped measurement during the interval time, the measurement results of
the current interval are discarded. The log of the current interval is not displayed in BackBack
field.
In this case, result data are re-calculated excluding the data of the current interval
when the measurement is stopped. This causes that "Count" and "Ratio" displayed
after the measurement will be different from that of during measurement.
The sum of interval time (multiplied interval time by the number of back logs) may
not match the differential time between displayed time at left top and right top after
the measurement.
Open the middle drop-down menu in the top row of buttons to select which
results you want to display on the screen.
OTNOTN SDHSDH, SONETSONET E1E1, E3E3, E4E4, DS1/J1DS1/J1, DS3DS3
Alarms/Errors
Performance
Alarms/Errors
Quality
Performance
TCM
Alarms/Errors
Performance
OTN options appear if the SDH/SONET signal is carried by OTN.
Touch a specific cell in a result table to zoom in on the corresponding result
item. The CountCount and RatioRatio fields are displayed on a ZoomZoom tab page. A Time vs.Time vs.
StatisticsStatistics tab page is also available. Touch the BackBack button to return to the
statistics screen.
To Next Page
Loading...
