SFP28SFP28
QSFP+QSFP+
QSFP28QSFP28
Electrical + ForcedElectrical + Forced
SFP + AutonegotiateSFP + Autonegotiate
SFP + ForcedSFP + Forced
SFP+SFP+
MDIXMDIX sets the electrical port to Medium Dependent Interface Crossover. Pin 3
and 6 of the electrical port on Network Master are used for the transmission,
pin 1 and 2 are used for the reception.
Selecting AutoAuto allows the Network Master to communicate not depending on
the LAN cable type (straight cable or cross cable) connected to the DUT.
Selecting the ForcedForced port mode with interface type specified as ElectricalElectrical will
display the following parameters:
Forced Mode SelectionForced Mode Selection
Allows you to select the ForcedForced mode speed and duplex capabilities. Available
choices are:
10 HDX10 HDX, 10 FDX10 FDX, 100 HDX100 HDX, and 100 FDX100 FDX
When autonegotiating with a port that is forced (i.e. not using AutonegotiationAutonegotiation), the
duplex for the port that is using autonegotiation will automatically be set to Half Duplex
(HDXHDX) and the speed to the speed used by the forced port. It is thus possible to have a
duplex mismatch without knowing it.
MDI/MDIXMDI/MDIX
Set the pin assignment of the electrical port.
AutoAuto sets the pin assignment of the Network Master electrical port to MDI or
MDIX automatically.
MDIMDI sets the electrical port to Medium Dependent Interface. Pin 1 and 2 of the
electrical port on Network Master are used for the transmission, pin 3 and 6
are used for the reception.
MDIXMDIX sets the electrical port to Medium Dependent Interface Crossover. Pin 3
and 6 of the electrical port on Network Master are used for the transmission,
pin 1 and 2 are used for the reception.
Selecting AutoAuto allows the Network Master to communicate not depending on
the LAN cable type (straight cable or cross cable) connected to the DUT.
Selecting the AutonegotiateAutonegotiate port mode with interface type specified as SFPSFP will
display the negotiated speed.
Only 1000Mbps FDX is supported by Autonegotiate function.
Selecting the ForcedForced port mode with interface type specified as SFPSFP allows you
to select the forced mode speed. Available choices are:
100 FDX100 FDX, 1000 FDX1000 FDX
When running 10G only ForcedForced mode is available.
WANWAN
Select the EnableEnable check box to enable insertion of the WAN interface sublayer
(WIS).
WAN interface sublayer is available for BERT application only.
Only ForcedForced mode is available.
Only ForcedForced mode is available.
Only ForcedForced mode is available.
To Next Page
Loading...
