SetupSetup
The configuration options available in the setup area of the screen are
described below. The status information is described in a separate section.
Enable SyncEEnable SyncE
The check box is enabled when the interface bit rate is 25 Gbps or less.
Select this check box to enable statistics of the quality level reported in the
received ESMC (Ethernet Synchronization Messaging Channel) messages and
the generation of Sync Alarm when such messages are missing.
Due to the properties of 10 Mbps Ethernet, the transfer of SyncE timing cannot be
guaranteed at this rate.
FollowsFollows
It is possible to let the Port 2 copy the setup from Port 1 by touching the
FollowFollow button. When this button is displayed in green, Port 2 continues to
follow Port 1 change. This button appears when the Port 1 settings can be copy
to Port 2.
ModeMode
Non-sync/MonitorNon-sync/Monitor: Network Master receives ESMC messages and monitors
the quality level, but does not transmit an ESMC message. Network Master
does not synchronize itself with the reference clock.
SynchronousSynchronous: Network Master transmits the quality levels specified in
QL
in
an ESMC message every second.
Ql TypeQl Type
Allows you to select a protocol/option. This changes the textual representation
of the quality levels on the result- and status pages.
QlQl
Allows you to specify the quality level to be indicated in the transmitted
Ethernet signal.
To Next Page
Loading...
