MU104011AMU104011A
The figure below shows the connector panel of the MU104011A.
QSFP28
Install a QSFP28 or QSFP+ optical transceiver.
The connectors for Port 1 and Port 2 are equipped.
SFP/SFP+/SFP28
Install SFP, SFP+, or SFP28 optical transceivers.
The connectors for Port 1 and Port 2 are equipped.
Ethernet
These connectors are electrical interfaces for Ethernet.
Use RJ45 connector to connect to them.
The connectors for Port 1 and Port 2 are equipped.
Sync Clock Output
This connector outputs the divided clock of the data rate which the
SFP28 or QSFP28 is transmitting.
Act
Lights orange when the optical transceiver becomes activated.
For Ethernet connectors, turns on orange while data are sent or
received.
Link Lights green when connection status becomes Link Up.
To Next Page
Loading...
