MU104014AMU104014A
The figure below shows the connector panel of the MU104014A.
QSFP-DD/
QSFP28
Install a QSFP-DD, QSFP56, QSFP28, or QSFP+ optical
transceiver.
This is the connector for Port 1.
QSFP28
Install a QSFP28 or QSFP+ optical transceiver. This is the
connector for Port 2.
SFP/SFP+/SFP28
Install SFP, SFP+, or SFP28 optical transceivers.
The connectors for Port 1 and Port 2 are equipped.
Ethernet
These connectors are electrical interfaces for Ethernet.
Use RJ45 connector to connect to them.
The connectors for Port 1 and Port 2 are equipped.
Sync Clock Output
This connector outputs the divided clock of the data rate which the
SFP28, QSFP28, or QSFP-DD is transmitting.
Act
Lights orange when the optical transceiver becomes activated.
For Ethernet connectors, turns on orange while data are sent or
received.
Link Lights green when connection status becomes Link Up.
To Next Page
Loading...
