1010..11 Device Test Setup and StatusDevice Test Setup and Status
Device Test sends the test pattern without the protocol frame to measure the BER of
the device.
1010..11..11 Physical Port SetupPhysical Port Setup
When the port is set up with an interface, touching the PortPort button in the
navigation area will display the screen shown below.
This screen allows you to specify the physical port configuration of the
currently selected port. It can also be used to inspect the current status of the
selected port.
The configuration options available in the setup area of the screen are
described below. The status information is described in a separate section.
Interface TypeInterface Type
Select the interface of the module.
Bit RateBit Rate
Select the bit rate standard.
Lane SelectLane Select
When bit rate is set to 100G Ethernet100G Ethernet, 200G Ethernet200G Ethernet, 400G Ethernet400G Ethernet, or OTU4OTU4,
select the number of lanes.
8 Lane8 Lane of QSFP56, 16 Lane16 Lane and 20 Lane20 Lane options mean "Logical lane', other
options mean "Physical lane'.
Physical lane: Lane of the optical transceiver's electrical interface such as
CAUI-4, CDAUI-8
Logical lane: Lane used for the logical process such as PCS (Ethernet)
To Next Page
Loading...
