1111..44..22 Connecting the Video Inspection ProbeConnecting the Video Inspection Probe
Connect the USB connector of the Video Inspection Probe to Network Master.
G0382A Autofocus Video Inspection ProbeG0382A Autofocus Video Inspection Probe
Replace the adaptor of the Video Inspection Probe with one that matches the
optical connector.
For handling the Video Inspection Probe, refer to the operation manual that
came with the Video Inspection Probe.
G0382A goes into the standby state unless the operation is performed for 60
seconds. If it enters the standby state, press the measurement button (M) on
G0382A or touch the icon on the Network Master before using it.
Network Master also supports following the Video Inspection Probes.
G0306A Video Inspection Probe
G0306B Video Inspection Probe
At the lower left area of the screen, this icon indicates the connection status of
the Video Inspection Probe.
1111..44..33 Test SetupTest Setup
When you go to the test setup of the VIP application, the following screen is
displayed.
This screen allows you to configure the parameters related to a VIP test.
To Next Page
Loading...
