1313..44 Upgrading the SoftwareUpgrading the Software
Connect the to the Network Master while updating the software. AC adapter
When updating the software with battery operation, make sure that there is 40% (or
more) power in the battery of the Network Master.
For a Network Master that connects the G0418A AC adapter or G0419A AC adapter
(400W) to the power connector, use the installer version 12.01 or later.
If you use an installer version 12.00 or earlier, the Network Master will not work properly.
1313..44..11 Installation by using USB flash driveInstallation by using USB flash drive
1. Copy the installer onto an empty USB flash drive.
2. If USB flash drive is inserted to the Network Master, remove it. If the Network
Master is powered-down while the USB flash drive is still inserted, there is a
risk that the USB flash drive may not operate normally after the installation.
3. Press the power button to shut down the Network Master. Never force to power
off by holding the power button pressed for several seconds.
4. Remove AC adapter and confirm the power button turns to gray.
5. Insert the USB flash drive into the Network Master.
6. Connect AC adapter to the Network Master.
7. Press the power button to boot the Network Master.
The Network Master will detect the installer stored in the USB flash drive, and
start installing the software. After the installation has finished, the Network
Master will reboot.
If the software is installed on battery operation without connecting AC adapter,
Network Master does not reboot. Press the power button to boot the Network
Master.
8. Check the software version at System Information on the Instrument ToolbarInstrument Toolbar.
9. Remove USB flash drive after the installation has completed.
1313..44..22 Installation via NetworkInstallation via Network
1. Install MX100001A MT1000A/MT1100A/MT1040A Control Software to PC by
referring to 3.4.1 Installation of Control Software.
2. Configure the Control Software and the Network Master so that they can
communicate via Ethernet by referring to 3.4.2 Connection and Setup.
3. Upgrade the software by referring to 3.4.5 Remote Upgrade.
To Next Page
Loading...
