S412E UG PN: 10580-00318 Rev. P B-1
Appendix B — Error Messages
B-1 Introduction
This appendix provides a list of information and error messages that could be displayed on
the LMR Master. If any error condition persists, contact your local Anritsu Service Center.
B-2 Reset Options
You can reset your LMR Master to Factory Defaults or use a Master Reset to return to the
FULL Factory Default condition from the menu system or from the Off condition.
Reset Via Instrument Menus
From the LMR Master menu system, press the Shift key, then the System (8) key to open the
System menu. Then press the System Options submenu key to open the System Options
menu. Then press the Reset submenu key to open the Reset menu (refer to “Reset Menu”
on page 5-16). From the Reset menu, press either the Factory Defaults submenu key or the
Master Reset submenu key.
Reset from OFF Condition
You can also reset the LMR Master by turning it Off and then restarting under one of the
following conditions:
Factory Defaults Reset:
Hold the Esc button while pressing the On/Off button. Continue holding the Esc button until
the Anritsu splash screen appears. You can then release the button. The LMR Master starts
up with many Factory Default settings (refer to “Factory Defaults” on page 5-16). Throughout
this appendix, this sequence is abbreviated as Factory Defaults (Esc+On).
Master Reset:
Hold the 8 key in the number keypad (also referred to as the System (8) key) while pressing
the On/Off button. Continue holding the 8 key until the Anritsu splash screen appears. You
can then release the key. The LMR Master starts up in FULL Factory Default condition (refer
to “Master Reset” on page 5-16). Throughout this appendix, this sequence is abbreviated as
Master Reset (System+On).
To Next Page
Loading...
