Anritsu S412E - 4-5 File Menu

4-5 File Menu File Management
4-8 PN: 10580-00318 Rev. P S412E UG
4-5 File Menu
Key Sequence: File
Save Measurement As: Press this submenu key to save the current setup
with a user defined filename. The default filename is changed using the Save
menu. To change the default file name, type in a new file with the touch
screen keyboard and press Enter. After a few seconds, the screen returns to
File menu. Press the Save Measurement As key again and the new file
name is used.
Save Measurement: Press this submenu key to display the “Save Menu”
on page 4-9 and the touch screen keyboard. Measurements can be saved to
internal memory or to a USB flash drive. The saved measurement can be
named by using the touch screen keyboard. By default, measurements are
saved to internal memory in a directory named /user. The save destination is
set with the “Save Location Menu” on page 4-10.
Save: Press this submenu key to display the “Save Menu” on page 4-9 and
the touch screen keyboard. Measurements can be saved to internal memory
or to a USB flash drive. The saved setup, measurement, or JPEG file can be
named by using the touch screen keyboard. By default, measurements are
saved to internal memory in a directory named /user. The save destination is
set with the “Save Location Menu” on page 4-10.
Save on Event: Press this submenu key to display the “Save On Event
Menu” on page 4-11. This submenu key is displayed only in LMR Analyzer
modes.
Recall Measurement: Press this submenu key to display the “Recall
Menu” on page 4-12. This menu is for recalling measurements from internal
memory or from a USB flash drive.
Recall: Press this submenu key to display the “Recall Menu” on page 4-12.
This menu is for recalling measurement or setup data from internal memory
or from a USB flash drive.
Copy: Press this submenu key to display the “Copy Menu” on page 4-13.
The Copy menu is for copying files or folders from internal memory or a USB
flash drive.
Delete: Press this submenu key to display the “Delete Menu” on page 4-14
and a selection box that shows the setup and measurement names and the
type, date, and time that the information was saved. Use the rotary knob or
the Up/Down arrow keys to highlight the file that is to be deleted and press
the Delete submenu key, then press Enter. Press the Esc key to cancel the
operation. Note that deleted files cannot be recovered.
Figure 4-6. File Menu
File
Copy
Recall
Recall
Measurement
Recall
Save
On
Event
Save
Save Measurement As
FileName.vna
Save
Measurement
Delete