Anthos A7 Plus - Page 37

A7 Plus – OPERATOR'S MANUAL
EN
37
Dental chair movement Joystick operation ( 3 ).
It controls the following movements:
Dental chair seat up.
Dental chair backrest up.
Dental chair seat down.
Dental chair backrest down.
To stop movement, release the control.
NOTE:
all dental chair movements are blocked when an instrument is
being used or the BIOSTER system is running.
NOTE:
it is possible to edit the joystick operation once the instrument is
extracted (see paragraph 5.1.1.2.7.).
Left-hand button operation ( 4 ).
• Holding down the button for at least 2 seconds with instrument
extracted:
Chip-air control: sends a jet of air to the Turbine or the Micromotor.
Air flow is activated by pressing the button; the jet of air is interrupted
as soon as button is released.
• Press the button shortly with the instrument extracted:
Activation or deactivation of instrument spray.
WARNING:
A short acoustic signal warns of the switching.
When the LED ( 8 ) is on, it indicates operation with spray.
Right-hand button operation ( 5 ).
• Holding down the button for at least 2 seconds with instrument
extracted:
Water Clean System Control: sends a jet of running water to
instruments such as the Turbine, the Micromotor and the Scaler for
rinsing the spray ducts. Water delivery is activated by pressing the
button ( 5 ); when the button is released, the jet of water is interrupted
and a blast of air is automatically activated to remove any residual
drops of liquid in the spray ducts.
• Press the button shortly with the instrument extracted:
Activation or deactivation of instrument spray.
WARNING:
A short acoustic signal warns of the switching.
When the LED ( 8 ) is on, it indicates operation with spray.
Right-hand lever operation ( 6 ).
NOTE:
lever operates only with instruments in rest position.
For safety reasons, the selected function starts only after the lever has
been briefly actuated and then released.
• Lever pushed downwards:
"Automatic dental chair return” programme activated.
• Lever pulled upwards:
Dental chair programme “B" activation.
Left-hand lever operation ( 7 ).
NOTE:
lever operates only with instruments in rest position.
For safety reasons, the selected function starts only after the lever has
been briefly actuated and then released.
• Lever pushed downwards:
Activation of the “Patient rinsing position” programme.
NOTE:
when the lever is actuated the second time, the dental chair
reaches its work position.