Anyview A6 - 13.4 Setting CO2

Patient monitor User’s manual
Chapter 13-7
13.4 Setting CO2
Select the CO
2
parameter area to enter CO
2
parameter setting menu.
 Setting Unit
Select 【 Unit 】 in the CO
2
parameter setting menu, and the options are
【mmHg】,【kPa】or【%】.
 Setting Apnea Alarm Time
For mainstream CO
2
and microstream CO
2
module, select【Apnea Alm】in
the CO2 parameter setting menu, you can select the apnea time as required in
the options. The monitor indicates an alarm when a pre-adjusted time has
elapsed since the last detected breath.
 Setting Expiring Cycle
The value of EtCO
2
and FiCO
2
in the CO
2
parameter area will be refreshed
in real-time. As for the mainstream CO
2
module and microstream CO
2
module,
you can set the method to calculate EtCO
2
and FiCO
2.
The【Et Cycle】can be set in the CO
2
parameter setting menu:
【One Breath】：calculate the EtCO
2
and FiCO
2
by every respiratory wave.
【 10s 】 or 【 20s 】： a time interval, during which the maximum CO
2
concentration is EtCO
2
, and the minimum CO
2
concentration is FiCO
2.
 Setting CO
2
Corrections
Temperature, water vapor in the patient’s breath, barometric pressure, and
the proportions of O
2
, N
2
O and Helium in the mixture all influence CO
2
absorption.
For mainstream CO
2
module and microstream CO
2
module, select【Set CO
2
Calibra. 】 in the CO
2
parameter setting menu, set these options as required
before zeroing:
——【Gas Temp】:Set the temperature of gas.
——【Barometric】:Set the atmospheric pressure.
——
【
Calibrate Gas
】
:Select the gas type of zeroing, the options are
【
Air
】
and【N
2
】.
—— 【 O
2
Compens 】 :Select the concentration of oxygen. It can be set to a