Anyview A6 - 15.5 ICG Parameter

Patient monitor User’s manual
Chapter 15-5
2. Another pair of sensors shall be placed on the midaxillary line at the xiphoid
process level.
3. The two sensors must be placed right on the opposite position (180°).
15.4.4 Input Patient Information
1. Select ICG parameter area to enter the ICG parameter setting menu.
2. Select
【
Input Information
】
.
3. Set the parameters from the popped up window, including 【 Gender 】 ,
【Age】，【Height】, 【Weight】, 【SYS】, 【DIA】,【 MAP】, 【CVP】，
【
PAOP
】，【
HB
】，【
SPO2
】
.
The parameters (height, weight, gender, age) are associated with the
parameters in the patient info of system. If the parameters have been changed
here, the parameters in the patient info of system alter at the same time, and
vice versa.
There are default value of Sys, Dia, Map, CVP, PAOP, HB and SPO2 user
may change them according to actual state.
15.5 ICG Parameter
Select ICG parameter area, and select
【
Hemodyna Param.
】
in the ICG
parameter setting menu, you can see the current hemodynamic parameters of
patient, as following list:
Abbreviation
Unit
Full name
C.O.
L/min
cardiac output
C.I.
L/min/m
2
cardiac index
SV
mL
stroke volume
SI
mL/m
2
stroke index
SVR
DS/cm
5
systemic vascular resistance
SVRI
DS·m
2
/cm
5
systemic vascular resistance index
TFI
Ω
thoracic fluid index
TFC
/kΩ
thoracic fluid content
HR
bpm
heart rate
Note: The HR reading is not obtained from ECG module, and it is obtained
from ICG module.