Anyview A6 - 4.2 Main Screen Select

Patient monitor User’s manual
Chapter 4-2
2. Select
【
Parameter Color Setup
】
, click the color block of corresponding
parameter, and then select the color according to your need from the popped
menu.
4.1.5 Sweep Mode
1. Select【Main Menu】smartkey→【Screen Setup】;
2. Set【Sweep Mode】to【Refresh】or【Scroll】：
【Refresh】:The waveform is still, refreshing from left to right.
【Scroll】:The waveform scrolls from right to left.
4.1.6 Selecting Parameter
You can select the parameters to be displayed according to the requirement
of monitoring and measurement.
1. Select【Module Set】smartkey.
2. From the popped menu, you can select the parameter to be displayed
according to your need.
4.2 Main Screen Select
You can set the screen layout as required. The setting method is as follows:
1. Select the【Main Menu】smartkey→【Main Screen Select】or select【Main
Screen】smartkey.
2. Select one screen according to your need.
The following are the display interface of screens, which may differ from
those on your monitor.