Anyview A6 - 24.3 Setting Recorder

Patient monitor User’s manual
Chapter 24-2
3. The alarm record triggered by out-of-limit parameter and so on;
4. Record started by manual operation and related to special function.
Note:
 If you want to know the introduction about alarm record, please
turn to Alarm chapter.
 If you want detail information of record about the special function,
please turn to the corresponding chapters.
24.3 Setting Recorder
Select the
【
Main Menu
】
smartkey→
【
Recorder Setup
】
, you can set the
recorder.
 Selecting The Record Waveform
The recorder can output three waveforms at one time at best. During the
setup of recorder, you can select 【 Waveform 1 】 , 【 Waveform 2 】 and
【 Waveform 3 】 in turn, then select waveform label in each option. Select
【 NULL 】 to close output of the waveform. These setup are suitable for real
time record and cycle record.
 Setting The Record Speed
Select 【 Record Speed 】 in the setup of recorder, select an appropriate
record speed according to your need, options are【12.50mm/s】，【25mm/s】
and【50mm/s】.
 Setting Periodic Recording Interval
You can set a certain time interval, and the recorder will automatically
start recording in line with the given time interval with the time span of 8
seconds. Select【Cycle record interval】in the recorder setting and select the
time interval as required. After setting, the recorder will start recording in line
with the given time interval.
 Setting Alarm Record
Select【 Alm Trigger 】 in the setup of recorder to record the alarm or not
when an alarm is happening. You can select
【
Off
】
or
【
On
】
.
