Anyview A6 - 22.2 Hemodynamic Calculation

Patient monitor User’s manual
Chapter 22-2
 Drug A, drug B and drug C are fixed to “g” series units: g, mg and mcg.
 Drug D is fixed to “unit” series units: unit, k unit and m unit.
 Drug E is fixed to “mEq” unit.
When define some kind of drug by yourself, you should select drug A,
drug B, drug C, drug D, drug E according to the unit series.
Caution: Drip speed and volume per drip are invalid for neonatal.
22.1.3 Titration Table
After finishing the calculation of drug dose calculation, select
【
Titration
】
in the interface of drug dose calculation to enter the interface of
titration table.
You can rejigger the following options in the titration table:
 Reference
：
You can select from
【
Dose
】
,
【
INF Rate
】
and
【
Drip
Rate】.
 Dose Type: Select the dose unit according to your need.
 Step: You can select from 1
～
10.
The data in the titration table will have some change after finishing the
above options.
You can also select or and turn page up and down to browse more
data. Select button 【 Record 】 , it will output the titration table data in the
current screen.
22.2 Hemodynamic Calculation
22.2.1 Calculation Step
1. Select 【 Main Menu 】 smartkey→ 【 Calculation 】 , then select
【Hemodynamic】.
2. Input each parameter’s value correctly:
a) If you are calculating the current patient, the monitor can get C.O.,
HR, Height and Weight automatically. And you need to put in the
other parameters’ value by yourself.
b) If you are not calculating the current patient, you need to input all of
the parameters’ value by yourself.