Anyview A6 - C.2 EMS Alarm Messages

Patient monitor User’s manual
57
C.2 EMS Alarm Messages
 System
Technical alarm:
Alarm messages
Cause
Level
Battery fail
Battery failure
Low
Battery low
Voltage of battery is too low
Medium
Time error
System clock isn’t set correctly
ECG comm err
ECG measurement failure or
communication failure
Resp comm err
Resp measurement failure or
communication failure
SpO
2
comm err
SpO
2
measurement failure or
communication failure
Temp comm err
Temp measurement failure or
communication failure
NIBP comm err
NIBP measurement failure or
communication failure
IBP comm err
IBP measurement failure or
communication failure
Prompt messages:
Messages
Cause
Level
Module mode
Connecting to the host monitor
No alarm
Sync Trends
Trends synchronize with the host
monitor
 ECG
Physiological alarm:
Alarm messages
Cause
Level
HR high
HR measuring value is above the
high alarm limit
Medium
User-Selectable
HR low
HR measuring value is below the
low alarm limit
Technical alarm:
Alarm message
Cause
Level
Off (RA、LA、LL、V1、
V2、V3、V4、V5、V6)
ECG electrode fall off the skin or
ECG cables fall off EMS
Medium