Patient monitor User’s manual
Chapter 19-2
Light up: When the battery is being charged.
Flash: When the battery is going to be charged fully.
Off: When the battery is fully charged or no battery in EMS or
disconnected to AC mains.
6. Power button
Press this button to turn the EMS on after the battery is installed.
Press and hold it for more than 1second to turn the EMS off.
7. Menu button
Press this botton, menu screen appears. Press it again to return to the
main screen.
Press this key to pause the alarm，press it again to cancel the pause.
9. Alarm acknowledge button
Press this button to acknowledge all active alarms. This switches off the
audible alarm indicators and alarm lamps.
10. NIBP button
Press this button to start or stop NIBP measurement.
To Next Page
Loading...
