Anyview A6 - Page 191

Patient monitor User’s manual
Chapter 19-18
during a period. Shorter average time leads to faster module response and
lower measurement precision when a patient’s SpO
2
value varies. On the
contrary, longer average time leads to slower module response and higher
measurement precision when a patient’s SpO
2
value varies. For a critically ill
person, short average time should be designed for facilitating timely disease
analysis. You may set response mode as per the following method.
Select
【
Average time
】
, upturn or downturn to choose an appropriate value.
You can choose from【Fast】,【Normal】and【Slow】.
(2) Nellcor SpO
2
setup
When using Nellcor SpO
2
module, You may need to do the following
operations in the 【SpO
2
Setup】menu except the settings in 10.5.1.
a. Setting Average time
Select 【 Average time 】 to choose an appropriate value. You can choose
from【Fast】,【Medium】.
b. Setting C-LOCK Switch
To provide more reliable saturation measurements in a high motion
environment, an ECG (R-wave) signal can be used as a time reference to
identify the pulse and synchronize saturation measurements. C-LOCK ECG
synchronization enhances performance while maintaining rapid response time.
When the patient is in moving or with low perfusion under the normal
ECG monitoring, You can set 【C-CLOK】to【On】.
（3）Masimo SpO
2
module setup
When using masimo SpO
2
module, You may need to do the following
operations in the 【SpO
2
Setup】menu except the settings in 10.5.1.
a. Setting Average time
Select【 Average time 】 to choose an appropriate value. You can choose
from【2-4Second】,【4-6Second】,【8Second】,【10Second】,【12Second】,
【
14Second
】
,
【
16Second
】
.
b. Setting Sensitivity Mode
You can set sensitivity mode of Masimo SpO
2
module according to use