Patient monitor User’s manual
Chapter 3-13
system time before implementing monitoring. If the configuration is to be
conducted during the process of monitoring, the user is advised to switch off
the monitor after exiting the current window and then restart it. The time for
the revision takes effect after the current window is exited.
To set the date and time:
1. Select【Main Menu】smartkey→【System Time Setup】.
2. Select
【
Date Format
】
, it can be set to
【
Year/Month/Day
】、
【Month/Day/Year】or【Day/Month/Year】.
3. Select【Time Format】, it can be set to【24h】or【12h】.
Caution: Changing the date or time will affect the storage of trends
and events, it may result in data loss.
3.14.4 Configuration Management
While monitoring, you may have modified some settings under a certain
condition, and users must enter the config module to save or delete the users
Caution: The user config can be saved or deleted only in the config
1. Selecting the default configuration
While monitoring, you may have modified some settings under a certain
condition, but these alterations are not necessarily suitable or proper,
especially at the time of patient changing. Therefore, you should restore the
default setting of factory as necessary to ensure that the monitor’s various
settings are suitable for the monitored patient.
To restore the factory configuration:
1) Select【Main Menu】smartkey→【Config Manage】, select【Select Default
Config
】
in the menu popped up. Select the config that users have saved in
advance accoding to your need and the patients’ type.
2) Select【OK】to confirm it.
2. Saving the user configuration
While monitoring, you can change the setting of monitor as necessary, and
To Next Page
Loading...
