Anyview A6 - Page 99

Patient monitor User’s manual
Chapter 9-5
9.4.2 Parameter Display
 For BLT SpO
2
and Nellcor SpO
2
Indicator of signal intensity
Description
“Weak Signal”
The signal strength is too weak to measure.
“*”
The signal strength is low.
“**”
The signal strength is good.
“***”
The signal strength is best.
Warning: When the “Weak Signal” is indicated, it means the signal
obtained by the SpO
2
probe is too bad. User should check
the patient’s condition and move the probe to other
appropriate position.
 For Masimo SpO
2
The Masimo module is intended to monitor the SpO
2
, SpMet, PVI, SpHb,
SpOC, PI, SpCO of patients.
The following figure shows the SpO
2
display screen, the display on your
monitor may be looked slightly different.
SpO
2
value
Signal intensity indicator
Pleth bar
SpO
2
unit

3
4
5