Specific operations for the vehicle
LICENSE PLATE HOLDER
•
Set three washers of suitable diameter
between license plate and its holder to
avoid damaging the license plate.
•
Remove the screw (2).
•
Remove the plastic cover (1).
•
Fit the rear pedal in its seat.
•
Fit the two TCEI M8X45 screws and
tighten with a torque wrench to a torque
of 18 Nm (13.27 lbf ft)
NOTE
REPEAT THE STEPS TO FIT THE PASSENGER FOOTPEG ON THE OPPOSITE SIDE.
WARNING
OPERATIONS REQUIRED TO RENDER VEHICLE COMPLIANT WITH TWO SEATER TYPE AP-
PROVAL.
Saddle replacement
RSV4 Factory a-PRC Pre-delivery
PRE DE - 515
To Next Page
Loading...
Need help?
General
