Controls
SILENCE BUZZER (Keyswitch Enabled or Disabled)
The internal panel buzzer is activated for any new condition. The buzzer will be
continuous for a fire alarm condition, intermittent for a fault warning and slow intermittent
for a condition warning.
The buzzer is silenced by pressing the Silence Buzzer Key. The yellow silence buzzer
LED will illuminate to indicate that the buzzer has been silenced.
RESET (Keyswitch Enabled)
This pushbutton will reset the fire panel.
DISABLE (Keyswitch Enabled)
This pushbutton calls up the Disable Menu (see Page 188). The yellow LED will indicate if
anything is disabled.
TEST (Keyswitch Enabled)
This pushbutton calls up the Test Menu (see Page 175). The yellow LED under General
Indicators will illuminate if the panel is put into a test mode.
Sounders
SOUND
Depends on operation selected by bits 5 and 6 of DIP switch on HOST PSU board. (*See
Appendix B of the FP2000 Installation and Commissioning Manual: LKFP2003). A red
LED indicates that the sounders have been activated.
DELAY ON/OFF
The programmed Sounder Delay (see Output Delays, Page 70) may be toggled ON or
OFF. Two LEDs indicate the state.
Depends also on operation selected by bits 5 and 6 of DIP switch on HOST PSU board.
(*See Appendix B of the FP2000 Installation and Commissioning Manual: LKFP2003).
FAULT/DISABLE (Keyswitch Enabled)
The Sounder Fault/Disable pushbutton allows the sounders to be disabled. The
associated LED indicates that the sounders have been disabled or that a sounder fault is
present.
The sounder fault can be:
• Sounder circuit open circuit
• Sounder circuit short circuit
• Bell fuse failure
To Next Page
Loading...
Need help?
General
