Aritech FP2000 Series Reference Guide

Other
PANEL
This button is used by global and local repeaters for panel emulation. Emulation mode is
activated with a global repeater by pressing the Panel key, then entering the number of
the panel to be emulated, and Enter ( ).
To stop emulation, the Panel key is pressed and then "0" and Enter ( ).
When a global repeater is emulating a panel it is not necessary to stop emulation before
emulating another panel. The global repeater will automatically stop the emulation before
trying to emulate another panel.
With a local repeater, pressing the Panel key will start emulation of the panel. If the panel
is already emulated, pressing the Panel key will stop emulation.
The yellow LED indicates whether a panel is emulated or not.
ALL
Used by the global repeater panel to send a command to all the panels the global
repeater is communicating with. The yellow LED indicates that the key was pressed,
meaning that the following command button to be pressed will be sent to all the relevant
panels.
THIRD SOURCE TEST
This key tests the third source battery when the panel is powered. Pressing the key will
sound the buzzer.
Zone indicators
Each zone has two indicators. A red LED indicates a fire and a yellow LED indicates a
fault, disablement or test. The zone fault LED will flash for a fault condition and be steady
on for disablement or test. The zones are numbered from the top left, from left to right.
Figure 3: 16 Zone Fire and Fault Indication

Aritech FP2000 Series Specifications

General

Brand	Aritech
Model	FP2000 Series
Category	Fire Alarms
Language	English