5 Outputs – All outputs are set to:
Type: None
6 System
Panel ID: Ø/ Ø
Port: INT - set to FEP; Baudrate 9600
CL - set to CL Device; Baudrate 600
SER1 - set to Setup; Baudrate 9600
SER2 - set to None; Baudrate 9600
Other ports - function: None
Network: Panels disabled
Repeaters disabled
Masters disabled
Access codes: *See Page 54
Field access: All menus have access level 1 except Field Access, Set
Times and Allocation have access level 2
Sounder/Fire Brigade Delay: 0 s
All times: 00h00
Sounder off time, Zones on
time and day mode time: Linked to none
7 Loops – loop data set to: Enabled
8 Logic table
All logic instructions are cleared and an “END” is placed in line 1.
To Next Page
Loading...
Need help?
General
