Arjo Tornado - Checking Nozzle Attachments and Hose Connections for the Nozzles (2.3); Checking Temperature Sensors (2.4); Checking Door Seals and Chamber Seals (2.5); Checking Fastening Points for Goods Holder (2.6)

70
6.3.4 Checking nozzle attachments and hose connections for the nozzles (2.3)
This is done to minimize the risk of leakage from the chamber and
from the hose system’s connections to the nozzles at the back
and on the side of the chamber. Failure to perform inspections can
result in leakage.
Check that the nozzles are properly attached to the inside chamber
ZDOO7LJKWHQWKHPLIORRVH)RUIXUWKHULQVWUXFWLRQVVHH³
Function and leakage inspection”.
6.3.5 Checking temperature sensors (2.4)
This inspection is performed to check that the temperature sensor
is working and that the lead-in on the top of the chamber is tightly
sealed. Failure to perform an inspection can result in inadequate
disinfection and leakage. The sensors’ value can be checked on
service lines 83:1 and 83:2. If the temperature in the machine is
more than ±1°C off, the temperature sensor must be recalibrated.
)RUIXUWKHULQVWUXFWLRQVVHH³)XQFWLRQDQGOHDNDJH
inspection”.
6.3.6 Checking door seals and chamber seals (2.5)
The inspection is done to check the seal on the door (the seal at
the bottom edge of the door) and the chamber seal (the seal that
runs along the front edge of the chamber). Failure to perform this
inspection can result in unwanted leakage of water and steam.
Check to make sure both seals are intact and have not become
ORRVHIURPWKHLUWUDFNV)RUIXUWKHULQVWUXFWLRQVVHH³)XQFWLRQ
and leakage inspection”.
6.3.7 Checking fastening points for goods holder (2.6)
This inspection is done to ensure that the three fastening points for
the item holders on the inner door are secure. Failure to perform
this inspection may result in the item holder ending up in the wrong
position, with unsatisfactory cleaning as a result.
Check that all item holders that are used are properly attached at
the fastening points.
 &KHFNLQJWKHRYHUÀRZFRQQHFWLRQ
This inspection is done to ensure that no water is leaking out from
WKHRYHUÀRZFRQQHFWLRQ7KHLQVSHFWLRQLVLPSRUWDQWWRSUHYHQW
leakage both during a normally functioning process and any major
leakage if the usual drain becomes clogged.
)RUIXUWKHULQVWUXFWLRQVVHH³)XQFWLRQDQGOHDNDJH
inspection”.