Arjo Tornado - Modifying Numerical Values

19
3.4 Check or change a numerical value on a line without a sub-line
number
• Press (increase line number) or (reduce line number)
so the display shows the right line number. Holding down the
button scrolls the value up or down for as long as the button
is pressed.
Line numbers always
appear to the left on the
display.
• Press
. The numerical value for the line number is
shown. 7KHQXPHULFDOYDOXHÀDVKHVLI\RXDUHDXWKRUL]HG
to change it.
• To change the numerical value:
࢓ If you want to change the value, press
(increase) or
(reduce) until the correct value is shown. Press
to store the new numerical value in the memory of the
computer.
Numerical value as
two digits
The numerical value
is shown to the left on
the bottom line of the
display.
࢓ If the numerical value has four digits, the two digits on
the left flash first. Change them and press
. The two
digits on the right now flash and can be changed in the
same way.
Numerical value as four
digits
First change the two digits
to the left…
...and then the two to the
right
• :KHQ\RXKDYH¿QLVKHGSUHVV
once more to show the
line number again.
• You can also just check the numerical value without
changing it:
࢓ When you are finished, press
. This returns you
to the line number.