Automatic Divider-rounder model Syncro
50/79
Use and maintenance manual (translation of the original instructions) - MASA6_en_2 of 23/03/2021
4 MAINTENANCE
4.1 FOREWORD
Unless otherwise specified, each intervention explained here can be considered as routine maintenance; any
other maintenance intervention must, instead, be considered special/extraordinary maintenance (for the
definitions of routine maintenance and special/extraordinary maintenance see par. 1.4); in case of doubt,
contact Artezen S.r.l.
ATTENTION!
Unless otherwise specified, every maintenance and cleaning intervention can be carried out only after
having:
- worn the PPE specified from time to time in the paragraphs of this chapter
- pressed the stop and emergency push-buttons ref. 2 in Figure 4
- turned the main switch to O - OFF, (see par. 2.3); lock it with a padlock to O - OFF
- pulled the plug from the socket (the plug should remain visible so that anyone can verify the absence of
electrical power) to prevent the machine or its parts from being started by thirds.
- waited for the time it takes for the residual voltage in the inverter to be discharged so as to prevent
electrocution (for more details see par. 4.5, par. 5.2 and par. 5.3.7).
Where it is necessary to remove a guard or disable a safety device, take every possible precaution to
prevent others from being exposed to consequential risks (for example, enclose the work area with white-
red chains and display warning signs for the risks involved with the work in progress); every guard must be
put back in place and secured with all the necessary fixtures and every safety device must be
reactivated as soon as the reasons for their temporary removal / deactivation no longer exist.
Anyone failing to follow these instructions and/or using the machine inappropriately or in a non-conforming
manner, who should be the direct or indirect cause of injury to persons or animals or damage to property, must
assume full responsibility for such negligence.
4.2 ROUTINE MAINTENANCE AND CHECKS
Before beginning, activate the safety measures indicated in par. 4.1.
At the end of the day or shift, clean the machine thoroughly (par. 4.4).
At the beginning of each working day or shift make sure that the guards and safety devices are intact
and efficient, by carrying out the checks illustrated in par. 5.2.3.
To Next Page
Loading...
