ARTEZEN SYNCRO - Electrical Maintenance; Spare Parts; Prolonged Stoppage or Exclusion from Service

Automatic Divider-rounder model Syncro
59/79
Use and maintenance manual (translation of the original instructions) - MASA6_en_2 of 23/03/2021
4.5 ELECTRICAL MAINTENANCE
Given the high risk and seriousness of the damage that may occur in case of an accident, every operation
even if simple (e.g. replacing a fuse), which directly or indirectly affects the electrical equipment of the machine,
must only be carried out by specialized technicians ( special / extraordinary maintenance ) expressly
appointed with technical and regulatory knowledge to carry out the work in a workmanlike manner and in safe
conditions; they must first read and fully understand the contents of this manual.
The same can be said for the replacement of safety microswitches for the protection of interlocked
safety guards: this operation also requires skills and mechanical knowledge to carry out the necessary
checks and any adjustments.
WARNING FOR MACHINES EQUIPPED WITH INVERTER
After having disconnected and reset the electrical power supply of the inverter, residual electrical
voltage remains that may be very dangerous for personal safety in case of contact with live
components; par. 5.3.7 provides further details on the subject and information on the precautions to be
observed in order not to be exposed to the related electrical risk.
4.6 SPARE PARTS
To order spare parts, contact the dealer where the machine was purchased, providing a brief description of the
part and / or its use; always mention the machine's serial number.
4.7 PROLONGED STOPPAGE OR EXCLUSION FROM SERVICE
In case of extended shut-down or exclusion from service, disconnect the machine from the electrical power
supply.
Carefully clean every part of the machine and then cover it with waterproof sheets to protect it from atmospheric
agents, dust, insects, rodents, etc. Prevent it from being subjected to shocks, tampering, damage, etc.
When recommissioned, a careful inspection is necessary to check the integrity and completeness of the
machine, as if it were the first time it was being started up.