ARTEZEN SYNCRO - Cleaning the Belts; Figure 37 - Cleaning the Head

Automatic Divider-rounder model Syncro
56/79
Use and maintenance manual (translation of the original instructions) - MASA6_en_2 of 23/03/2021
 Finally, close the access door.
4.4.7 CLEANING THE BELTS
Before beginning, activate the safety measures indicated in par. 4.1. Wear abrasion-resistant gloves,
shoes with reinforced toe, dust-proof face mask, and protective goggles.
Start the machine without load (for up 10 minutes) and clean the belts using a brush with medium-consistency
synthetic bristles.
IMPORTANT! Do not use the following items to clean the belts:
- knives, scrapers, etc.: they may cause serious damage to the belts.
- metal abrasive pads; they may release metal fragments on the belts with possible (and probable!)
contamination of the product that will be placed there
- chemical products (detergents, soaps, etc.)
If the belts have worn, frayed, or cut surfaces, replace them immediately to prevent them from ripping during
production, but above all to guarantee the hygiene of the product being processed
NOTE!
Never forget any type of foreign material inside the dough compression chamber!
Pos. 3
Pos. 4
Pos. 5
Pos. 6
Pos. 1
Pos. 2
Figure 37 - Cleaning the head