4-10 Preliminary November 4, 1998 MAX 4000 Series Hardware Installation Guide
Navigating and Securing the Interface
Special display characters and keys
E1 slots
The built-in T1 or E1 lines are slot 1 and slot 2 (menu 10-000 and 20-000). Each T1 or E1 slot
includes two lines. The menus for configuring and testing the lines are organized as follows:
10-000 Net/T1 (Net/E1)
10-100 Line Config
10-200 Line Diag
20-000 Net/T1 (Net/E1)
20-100 Line Config
20-200 Line Diag
Expansion slots
The six expansion slots are slots 3 through 8 (menus 30-000 through 80-000), numbered as
shown in Figure 4-2.
Ethernet and WAN slots
Slot 9 is Ethernet slot menu 90-000. The Ethernet menu contains submenus and profiles related
to the local network, routing and bridging, and WAN connections.
Slot A is the EtherData slot menu A0-000. For the MAX with built-in Ethernet, this menu is
not applicable.
The serial WAN port is slot B (menu B0-000).
Main Edit Menu example
Following is an example of a Main Edit Menu for a unit with expansion modules installed in
slots 3 through 8. (Note that the menu item for slot A is not applicable to the MAX with
built-in Ethernet.)
Main Edit Menu
00-000 System
10-000 Net/T1
20-000 Net/T1
30-000 Host/Dual
40-000 Host/BRI
50-000 Net/BRI
60-000 BRI/LT
70-000 V.34 Modem
80-000 V.110
90-000 Ethernet
A0-000 Ether Data
B0-000 Serial WAN
Now that you understand the MAX user interface, you can proceed to the Network
Configuration Guide for your MAX.
To Next Page
Loading...
Need help?
General