3-36 Preliminary November 4, 1998 MAX 4000 Series Hardware Installation Guide
Quickstart
Implementing a basic configuration
5 Specify the amount of attenuation to add to the line’s network interface.
If the MAX does not have an internal CSU, select the N/A settings. Otherwise, select the
Buildout value to provide the proper line attenuation. The default is 0dB.
6 If you cannot accept the default channel-type setting of switched for every channel on
the line, set the Ch N parameter as required.
– Switched (the default)
– Nailed (dedicated)
– Unused (not in service)
Note: To test the line later, you must have at least two switched channels. If you plan to
use a channel for drop-and-insert (D&I), you can enter it as Switched for the Quickstart
and then change it to D&I for the final installation.
For R2 signaling, route incoming calls
If you using R2 signaling, configure incoming call routing for the E1 line by setting the Ch N #
and Ch N Slot parameters as follows:
1 For each Ch N # parameter, enter the unique digits of the phone number used to reach this
channel.
For example, if your line is set up as illustrated in Figure 3-8 on page 3-26, enter 1111 for
the first 12 channels, and 2222 for the last 12 channels.
2 For each E1 channel that will answer analog calls, set the Ch N Slot parameters to the
number of the slot that contains the modem card.
For example, if the modem card is in slot 5, set Ch 1 Slot=5, Ch 2 Slot=5, and so on, up to
the total number of analog calls you want the MAX to accept on this E1 line. These
settings tell the MAX to route incoming analog calls to the digital modem card.
3 For each E1 channel that will answer digital calls, set the Ch N Slot parameters to 9, the
default number of the slot that contains the MAX unit’s bridge/router module. These
settings tell the MAX to route incoming digital calls to the bridge/router module, to be
bridged or routed to their destination.
Save the Line N profile
At this point, you have configured a line and are ready to save its profile, as follows:
1 Press the Left-Arrow or Escape key to exit the Line 1 profile.
A confirmation menu appears:
EXIT?
>0=ESC (Don’t exit)
1=Exit and discard
2=Exit and accept
2 Press 2 to save and exit.
To Next Page
Loading...
Need help?
General