3-34 Preliminary November 4, 1998 MAX 4000 Series Hardware Installation Guide
Quickstart
Implementing a basic configuration
Specify signaling mode
1 From the Main Edit Menu, select the slot that contains your Net/E1 card (for example,
10-000).
The slot’s menu appears:
10-000 Net/E1
>10-100 Line Config
10-200 Line Diag
2 Select Line Config.
The Line Config menu appears:
10-100 Line Config
>10-1** Factory
10-102
10-103
10-104
3 Select the currently active slot profile, 10-1** Factory.
The selected slot profile appears:
10-1** Factory
>Name=
1st Line=Trunk
2nd Line=Disabled
Line 1...
Line 2...
4 Select Line 1.
The Line 1 subprofile appears:
10-1** Factory
Line 1...
>Sig Mode=R2 ^
NFAS ID num=N/A
Rob Ctl=Wink-Start
Switch Type=N/A
Framing Mode=D4
Encoding=AMI
FDL=N/A
Length=N/A
Buildout=0 dB
Clock Source=Yes
Pbx Type=N/A
Delete Digits=N/A
Add Number=N/A
Call-by-Call=N/A
Ans #=N/A
To Next Page
Loading...
Need help?
General