Ascend T1 MAX series User Manual

3-14 Preliminary November 4, 1998 MAX 4000 Series Hardware Installation Guide
Quickstart
Implementing a basic configuration
2 Select Mod Config.
The Mod Config submenu appears:
50-000 Mod Config
Module Name=
Ans 1#=
Ans 2#=
Ans 3#=
Ans 4#=
3 Set the Ans N # parameters by entering the unique digits of the telephone numbers dialed
by callers who use analog devices. For example, Ans 1#=1111. This setting tells the
MAX to route all calls coming in from phone number 555-1111 (the hunt group for analog
callers) to the digital modems.
4 Press the Left-Arrow or Escape key to exit the current Modem profile.
5 In the confirmation menu, press 2 to save and exit.
6 Press the Left-Arrow or Escape key to return to the Main Edit Menu so that you can
configure routing for MAX incoming modem calls. From the Main Edit Menu select
Ethernet > Mod Config > WAN Options.
The WAN Options profile appears:
90-C00 Mod Config
WAN options...
Dial Plan=N/A
Ans 1#=
Ans 2#=
Ans 3#=
Ans 4#=
Pool#1 start=0.0.0.0
Pool#1 count=0
Pool#2 start=0.0.0.0
Pool#2 count=0
Pool only=No
Pool Summary=No
7 Set the Ans N # parameters by entering the unique digits of the telephone numbers by
callers who use analog devices. For example, set Ans 1#=2222. This setting tells the
MAX to route all calls coming in from phone number 555-2222 (the hunt group for digital
callers) to the MAX Ethernet module.
8 If you are going to dynamically assign addresses to incoming callers, set the following
parameters:
– Pool#1 Start–The first IP address in the pool
– Pool#1 Count–The number of IP addresses in the pool
9 Press the Left-Arrow or Escape key to exit the Ethernet Mod Config profile.
In the confirmation menu, press 2 to save and exit.
You have now set all the parameters necessary for your T1 line configuration.

Ascend T1 MAX series Specifications

General

Brand	Ascend
Model	T1 MAX series
Category	Network Router
Language	English