Ascend T1 MAX series User Manual

3-20 Preliminary November 4, 1998 MAX 4000 Series Hardware Installation Guide
Quickstart
Implementing a basic configuration
4 Select Encaps Options.
The Encaps menu appears:
90-101
Encaps options...
Send Auth=None
Send PW=N/A
Aux Send PW=N/A
Recv PW=
DBA Monitor=Transmit
Base Ch Count=1
Min Ch Count=2
Inc Ch Count=1
Dec Ch Count=1
MRU=1524
LQM=No
LQM Min=600
LQM Min=600
Link Comp=Stac
5 These parameters can remain at their default settings.
6 Select IP Options.
The IP Options subprofile appears:
90-101
Ip options...
LAN Adrs=0.0.0.0/0
WAN Alias=0.0.0.0/0
IF Adrs=0.0.0.0/0
Preference=100
Metric=7
Private=No
RIP=Off
Pool=0
Multicast Client=No
Multicast Rate Limit=100
Client Pri DNS-0.0.0.0
Client Sec DNS=0.0.0.0
Client Assign DNS=Yes
7 If you are configuring a Connection profile for a device with its own IP address, set the
following parameters:
– LAN Adr —Enter the IP address including any subnet mask, of the remote unit, then
press Enter to return to the list of parameters.
– WAN Alias—If the far-end device is non-Ascend and requires numbered interfaces
with PPP encapsulation, enter the IP address of the remote unit’s WAN interface (not
its Ethernet interface), then press Enter to return to the list of parameters.
– IF Adrs—If you are implementing interfaced-based routing on the MAX, enter the IP
address of the port used on the MAX side of the link.
8 If you are configuring a Connection profile for dynamic address assignment, set the
following parameter:
– Pool—The IP address pool from which you want to assign this client an address. IP
address pools are configured in the Ethernet > Mod Config > WAN Options submenu.

Ascend T1 MAX series Specifications

General

Brand	Ascend
Model	T1 MAX series
Category	Network Router
Language	English